Art. No. 5985
Construction
In the lower part of the cabinet, you can see the tunnel, made up of the base and an upper board. In the middle, there are three cross-reinforcements. At the top of the cabinet, behind the cut-out in the baffle for the mid- to high-range unit, is the enclosure required for the mid-range cone, made up of two wooden boards. Three 8 mm holes has to be drilled into the rear board of the mid-range enclosure for the connection leads. These holes have to be sealed well.
Fitting the TIW 250 XS into the side is a special feature. The mounting board for the TIW 250 XS (346 x 297 with a 235 mm cut-out) itself is glued in place from inside behind the round cut-outs in the corresponding side panel. This means that the bass driver can be sunken by 19 mm (19 mm = thickness of the boards). For optical reasons the side panel cut-out must be made extremely accurately.
The crossover unit is mounted on the side panel behind the bass port.
Inner damping
The damping uses one mat placed in the medium range cabinet. The remainder is evenly distributed throughout the cabinet. The area above the tunnel opening (at the rear of the front panel) up to the lower edge of the reinforcement remains free. If, as a result of the acoustics in the room, the low-range bass is too powerful, damping this area will have a corresponding effect on the overall bass output level.
Component parts list for 1 box
The kit includes all the components listed here but not the cabinet.
Cabinet parts list for 1 box
| Parts |
Size (mm) |
Quantity |
| Material: 19 mm chipboard or MDF |
| Rear panel |
1051 x 197 |
1 |
| Top panel |
359 x 197 |
1 |
| Bass-reflex channel |
270 x 197 |
1 |
| Brace |
100 x 197 |
2 |
| Brace |
60 x 197 |
1 |
| Midrange rear panel |
500 x 197 |
1 |
| Midrange bottom panel |
43 x 197 |
1 |
| Bottom panel |
378 x 197 |
1 |
| Side panel |
378 x 1150 |
2 |
| Mounting board woofer |
346 x 297 |
1 |
| |
| Material: 22 mm chipboard or MDF |
| Front panel |
235 x 1150 |
1 |
|
