Do you have any questions?

VOX 252 MTI

The VOX 252 MTI is the current highlight in the VOX series. The uncompromising approach, involving fitting the TI 100 8 OHM as the low- to mid-range unit and the MHT 12 8 OHM as the tweeter, worked highly successfully in the TOPAS. Following the basic design concept of the VOX series, this system is fitted with two TI 100 8 OHM 's as low- to mid-range units and the TIW 250 8 OHM as the woofer.

One particularly convenient innovation is used for the first time in the VOX 252 MTI: it is now possible to tune the bass output level on the crossoverunit. Depending on the acoustic properties of the room and personal preference, the bass output might be too strong, if the speakers are placed close to a wall, for example. The adjustment unit is mounted on the crossover unit directly parallel to the woofer and enables to listener to adjust the output level between 70 Hz and 150 Hz. The lower-frequency bass is not affected. Increasing the resistance affects the bass output: 10 ohms for a minimal reduction in bass and 3.3 ohms for maximum reduction. If the adjuster is left open (i.e. resistance is infinite), bass output reduction is deactivated.

Press

Extract from Klang & Ton

With their VOX 252 MTI, VISATON have, once again, created great results. This is not only the best VOX there has ever been, it is, in my opinion, the best sounding VISATON speaker of all. Ready-made speakers of this quality will often cost as much as 10,000 a pair. The DIY concept is definitely a winner here.

Technical Data
Component parts list
Additional Content
Rated power 200 W
Maximum power 350 W
Nominal impedance Z 4 Ohm
Übertragungsbereich (-10 dB) 28 - 40000 Hz
Mittlerer Schalldruckpegel 83 dB (1 W/1 m)
Trennfrequenz 200 / 4000 Hz
Gehäuseprinzip Bassreflex
Net volume 63 l + 4 l (ohne BR-Kanal)
Außenmaß Höhe 1150 mm
Außenmaß Breite 235 mm
Außenmaß Tiefe 400 mm

Component parts list for 1 box

Tweeter:
MHT 12 8 Ohm
1 piece
Midrange
TI 100 8 Ohm
2 pieces
Woofer:
TIW 250 8 Ohm
1 piece
Crossover:
"VOX 252 MTI"
Terminal:
BT 95/75
1 piece
Damping material:
4 bags
Special wood screws:
5 x 30 mm
4 pieces
Wood screws:
3.5 x 19 mm
12 pieces
Countersunk screws:
3.5 x 25 mm
4 pieces
Material for speaker covers:
width 50 cm
1 m
Cable:
2x 1.5 mm2
2 m
2x 2.5 mm2
2.5 m

Frequency- and impedance response

Do you have any questions?

Contact us