Do you have any questions?

FIESTA 25

The strength of horn speakers is, without doubt, in their dynamism. Even short, extremely high peaks and sustained high volumes are reproduced without effort because horns are able to convert electrical energy into sound energy very efficiently. In many cases, this benefit is impaired by the fact that the sound is slightly distorted. This is not the case with the FIESTA 25. Emphasis has been placed in this development on achieving a frequency response curve which is as linear as possible - a key requirement for undistorted sound reproduction and a joy to listen to even if the listening session carries on into the small hours. In order to keep the cabinet down to a reasonable size for living rooms, the bass department does without a tube and instead uses large diaphragms in twin W 250 S - 8 Ohm in a closed compartment.

The striking feature of the FIESTA 25 is the mid-range horn. Here, the DK 8 P - 100 V/15 W horn speaker, based on the pressure chamber principle and borrowed from the public address department, has been applied as a low-impedance version (without the 100 V transformer). It differs from the many other horn speakers of this type which are available on the market by its remarkably good characteristics in the mid-range from 500 to 5000 Hz. Consequently, it is only applied within this range. The tweeter is the HTH 8.7 - 8 Ohm constant directivity horn which has already proved its worth in the MB 208/H kit proposal.

This unusual combination being rather quirky, it was necessary to devise a smart crossover design to achieve the high demands placed on the speaker and satisfy even HiFi standards. Even though the frequency response cannot be as linear as it would be with other loudspeakers, the listener is rewarded with remarkably good sound quality. The FIESTA 25has a pleasant sound ranging from low bass through the clear, well-defined mid-range up to the finest of the higher frequencies. In contrast to standard HiFi speakers, however, this one can easily produce extremely high peak levels and is quite happy to make the walls bulge with continuous, high-level volumes. Provided the listener takes up a suitable central sitting position between the speakers, the well-controlled directivity of these tightly bundled horn speakers allows well-recorded sound to be easily located while ensuring good range layering.

It is fair to say, then that this is a HiFi speaker which will provide very high levels of satisfaction.

Press

Extract from Klang & Ton 01/07

"The idea of incorporating lots of surface area and masses of volume in a single speaker at an affordable price has been put into practice once again in a thoroughly consistent manner, even if it meant raising the overall standard of the system a notch or two. (...) This loudspeaker can easily deal with even very high output levels, punches out crisp bass, produces brilliantly clear treble and shows more than enough dynamism across all frequency ranges. (...) Vocals and percussion come over powerfully but always pleasantly and well-balanced. (...) Bubbling over with contrast, with a carefully measured shot of directivity, solid, clear bass and a highly satisfying overall sound quality even at realistic volumes, this speaker generates a real live-on-stage feeling. (...)

(...) The speaker combines the pleasure of high volumes with a surprisingly balanced overall quality and applicability, even with highly demanding recordings - it is, as it were, a fun speaker with excellent living-room manners."

Technical Data
Component parts list
Additional Content
Rated power 250 W
Maximum power 350 W
Nominal impedance Z 4 Ohm
Übertragungsbereich (-10 dB) 40–20000 Hz
Mittlerer Schalldruckpegel 90 dB (2.83 V/1 m)
Trennfrequenz 600 Hz / 3500 Hz
Gehäuseprinzip geschlossen / closed
Net volume 115 l
Außenmaß Höhe 1200 mm
Außenmaß Breite 320 mm
Außenmaß Tiefe 400 mm

Component parts list for 1 box

Tweeter
HTH 8.7 - 8 Ohm
1 pc.
Midrange driver
DK 8 P - 100 V/15 W
1 pc.
Woofer
W 250 S - 8 Ohm
2 pcs.
Crossover
Fiesta 25
1 pc.
Terminal
ST 77
1 pc.
Damping material
Polyester wool
8 bags
Wood screws
4 x 20 mm
18 pcs.
Countersunk screws
3.5 x 25 mm
10 pcs.
Screw / nut
M 8 x 30
2 pcs.
Cable
2 x 1.5 mm²
4 m
Material for speaker covers
50 x 50 cm
1 pc.

Frequency- and impedance response

Do you have any questions?

Contact us